FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1832 total: showing 1721-1740)

Where is the interface cable for the WindSonic?
Do you have 1-d anemometer having 4 Hz or higher frequency to measure the vertical wind velocity?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart data logger to give wind speed and direction on a non-fixed platform?
Can the CR5000 store data with a rate of 1000 Hz?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?
Can the CR1000 measure 4 to 20 mA signals?
Can I use the digital camera with my RF network and transmit the images back to the office using Loggernet?
I am trying to set up a CC640 with a CR10x (not the 2M variety) to send images via a freewave radio. I'm wondering if I need loggernet 3 (I have 2) or if I just need the lvcmd.exe file to view these pics through the logger?
What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
The measurement instructions will likely remain the same but in addition to the multiplier and offset, the type of pulse may change for the wind speed and the excitation voltage may change for the wind direction. The manual easily explains how the logger needs to be programmed.
If I replace an existing wind set with the wind monitor, will I have to change more than the multiplier and offset in the datalogger program?
What is the power consumption (mA) of the 05103, 05305, 05108, and 05108-45 anemometers?
What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
Can I install the 21X Micrologger to capture soil water?
Can the CR5000 store data with a rate of 1000 Hz?
When I dial up to the unit I can see the barometric pressure data in real time. When I attempt to collect data from the unit via dial up or even via storage module, the barometric data are all 0's.

Previous Next