FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1832 total: showing 1761-1780)

I'm looking for a wind monitor (speed and direction) that could be used with a tethered balloon system. The main feature I'm concerned with (aside from weight) is a built-in datalogger. Would you have anything that would meet this requirement or do all your systems require direct wiring to a separate datalogger.
Can the wind monitor be used without your datalogger?
If an existing wind set is replaced with a wind monitor (05103, 05103-45, 05106, 05305), will more than the multiplier and offset have to be changed in the data logger program?
We have an R.M. Young marine anemometer with a cable that is about 13 ft long. We would like to extend the cable another 20 ft or so. Do you sell a separate extension cable for the anemometer?
What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
What is the procedure for orienting my wind sensor to the cardinal directions so that the wind direction readings are correct?
How can the 229 be calibrated?
How are readings obtained from the 229?
Is calibration of the 229 available?
If several 229 probes begin returning very low positive and negative values for dT, what might be the cause?
How should the AM25T be used?
Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
How can the data logger build a text string and send it out the RS-232 port?
I plan to set up an eddy covariance system in a remote wetland located in Michigan's upper peninsula. This site does not have power and is difficult to get to. I would like to set up a communication system that allows me to monitor the data from my office (Michigan Tech). There is a research station near the site (less than 5 km away--Seney National Wildlife Refuge) that could be used to collect the data before bouncing it to me.
I am writing from Universidad de Cuenca in Ecuador, and I would like to know if we can use ST-20 Argos Satellite Transmitter in Ecuador? Are there other choices for Ecuador?
Do Campbell systems support other satellite networks such as Iridium and Orbcomm? If the answer is "yes", do you know if the area of Somalia is covered by those services?
I need help with a satellite telemetry system to be used in northern Somalia for hydrological and meteorological station data transfer for a flood early-warning application.
What would be the best telemetry system for remote data collection from valley bottoms in a dense redwood forest?
I am looking for information on the 21X Micrologger, specifically about removal of the expansion memory module. I was trained on the CR10X, but have no info on the 21X.
Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a data logger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?

Previous Next