FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1818 total: showing 321-340)

What is the maximum number of AVW206 devices that can be connected to one RF401A?
How can an RF401A be used to communicate as both a sender and a receiver with an RF400?
Is there a way to remotely connect to an RF401 to correct an Active Interface setting in the Device Configuration Utility?
Is there a Status table for the RF401?
How is callback programming done using an RF401A?
Can an RF401 handle high-frequency data, such as 10 Hz?
Is it possible to remotely change the settings of a remote RF401A, such as through a radio-to-radio transmission?
If two RF401A radios are using different operating systems, does that affect their ability to communicate?
Is there a limit to the length of antenna cable that can be used with an RF401A?
Does initiating RF401A radios require dc power, or is power via the CS I/O connection OK?
Does the RF401A have any identified sensitivities to adjacent operating radio equipment?
Is there a setting to increase the power output of an RF401?
Is it possible to configure the RF401A as a stand-alone router?
Is there a maximum current that can be sourced through the SW12V?
Is there a maximum voltage that can be sourced through the SW12V?
Using an SW12V, can the 12 V power lead be run to a source other than the data logger 12 V?
What are the voltage and current requirements for toggling the switch of an SW12V?
When should the desiccant inside an enclosure be replaced?
What factors affect the amount of desiccant needed in an enclosure?
If LoggerNet is running on a PC, does that mean that LoggerNetData’s DataFiler can’t be used to access the cache for that instance of LoggerNet?

Previous Next