FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1818 total: showing 361-380)

If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the data logger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?
How can four GPS16X-HVS receivers be connected to the COM ports of a data logger to read all four NMEA strings?
Does the regulator for the 25295 draw power from the battery during the night?
Does the regulator for the 25295 have the Low Voltage Disconnect feature?
What would happen if two data loggers were connected directly through CS I/O ports via an SC12 cable?
What is the pinout for the SC12 cable?
Can a solar panel provide enough power to charge a weather station?
Can the 41303-5A 6-plate radiation shield or the 41003-5 10-plate radiation shield be used with the HMP155A?
To connect the HMP155A to a CR800 or CR1000, should a differential or single-ended channel be used?
After reinstalling LoggerNet, why might the RTMC file no longer see any data loggers under LoggerNet?
After installing an RTMC patch, what would make the text and label look fuzzy?
Is there a way to send email from a data logger and simultaneously monitor other data from the data logger using RTMC display?
What is the difference between the Connect screen graph and the RTMC chart?
How can RTMC data be published to a web page?
Can RTMC be used to create a real-time XY plot of two sensors?
Can a SetPoint box in RTMC be used to change a multiplier and offset that are programmed in Edlog or CRBasic?
For RTMC, how can the SetPoint component variable be configured to RW (read/write)?
How can data from a BACKUP file and a DAT file both be displayed in RTMC graphs?

Previous Next