Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
RS-232 Question Larry@UFL 2
Problem with mesures of t107and cs616 with mux AM16/32 FB5802 0
Code for latent heat flux with KH20 aoliveira 0
Issue in upgrading CRBasic to version 3.8 hal9000 4
Cr1000 and HADCP column shift parthi 1
Send one way data between data loggers using IP R.AriasFont 1
Etiquette for CRBasic DOI dphuber 0
CELL 215 AND CR1000. PROBLEMS WITH REGISTRATION IN PRIVATED APN iperez 16
High(er) frequency measurements jonny 2
Legal/Trademark disclaimer to include with open source project thyyppa1 0
CPI network - sync two loggers? HMNIBIO 1
patch loggernet 4.5 kokihualpa 2
New Loggernet 4.6 language Makada 1
Measurement Matters - Datalogger Backup jra 6
message Warning: Variable period out of bounds. FB5802 1
New Loggernet 4.6 language Makada 5
VOLT108/116 excitation port sharing HMNIBIO 2
CR1000 and formatting of values for sending to APRS/CWOP WX4GPS 3
Modbus with CR1000X chalit 2
[CR200X] reading data with perl lbrutti 8
Conexion VisualWeather y Cr1000 (konectgds) Ricardo1 1
CR300 cell200 cellular module start-up failure parthi 0
convert time and date from sec kokihualpa 3
send hex to modbus device chalit 1
SDM-IO16 with CR6 Ruben Calleja 1
Volumetric Water Content Measurement Alexandros 0
rv50 comunicador Ricardo1 1
write tablefile via flag dandol 4
Cell210 Not Registering on Network MAQS017 2
SerialIn of a long ASCII string on CR6 pitacco 1