If I am creating a table called (Table1) with 5 minute averaged data, and then I want at midnight a daily table created that is going to just look at all the 5 miute averaged data in the table for the last day, what is the format of the command in the (table2) going to look like to lets says pull the maximum 5 minute observation for lets say TAIR (air temperature), because I don't believe when I use short cut it created just a maximum with the highest scan TAIR and I woudl prefer it just at midnight reviewed the specific logged values and produces the maximum logged in the table vs the highest scan. That you if you can provide me an example of that syntex where it references a table name.
I'm not sure that I completely understand what you do, if what I suggest is wrong, try to better describe your question.
If you want to create a daily table that uses the data already processed in / from the table 1 you can copy in the numeric (public) historical data and use these new variables as input for the calculations of the daily table.
So you can copy in the numeric, the 5 minute data (table1) with the command "GetRecord".
Smile
Dear All
I want to collect the data from logger by remote
I don't want to go station every week or every month
or may be station can send me data automatically.
I installed Sim Card with static IP address
and tried to configure the modem
Used Dev. Conf.Ut. 2.13v and send some AT commands to modem fastract xtend
then I configurated SC105 interface and Data logger CR1000
then I selected the ‘Settings Editor’ tab, followed by the ‘PPP’ tab and saw the IP Address information of our GPRS SIM Card.
but what I need to do next for collecting data from office or from home
Final Storage Tables Not Defined -what is it?
best regards
Rasim
@noviok
I think all explained in the manual of CS-GPRS campbell using your own modem.
Smile