Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Modbus master default serial settings

Anton Feb 13, 2017 01:10 PM

The CRBASIC help says:

ModbusMaster

 The datalogger uses 8 data bits and no parity for Modbus communication. This can be changed by preceding the Modbus instruction with a SerialOpen instruction that sets the desired data bit and parity values.

Is this with one or two stop bits? 

JDavis Feb 17, 2017 11:29 PM

One stop bit

Anton Feb 19, 2017 10:24 PM

Thanks

Log in or register to post/reply in the forum.